Rihac IP5200 Manuel d'instructions

Premium Continuous Ink Supply Systems. Instruction Manual For Canon Printers IP3000, IP4000, IP5000 I860 & I865. MP760& 780 (addi

10b) Remove the orange cartridge cover from each of your new cartridges. This is done by slowly moving the clip in an anticlockwise direction. Bewa

11b) Adjustments to the tube length may be required. To check this, move the cartridge holder left and right to each end of the printer. It should r

12e) Release the tube clamp on the front of the CISS by rolling it up. f) Reinsert power cable to the rear of your printer and perfor

133) Refilling your CISS a) Do not allow the ink levels to fall below the refill line. To refill each ink simply remove the air filters and repl

144) Priming a) Only prime your CISS if excess air (5cm or more) is present in the tubing. It is recommended that priming is conducted in a suita

15e) Draw air into the syringe (DO NOT ATTACH A NEEDLE) then place it in the hole left by the removed travel plug. f) Push down ver

165) Trouble shooting a) Leaking Ink If your CISS appears to be leaking from the cartridges, please ensure that you do not have it placed higher

17 d) Flashing Printer Lights If both lights are flashing on the top of your printer it will generally indicate that your printer waste pad is fu

18

19

2

20 • CIS Systems • High Grade UV Dye Inks • Pigment Inks 157 Union Road, Ascot Vale, Vic 3032 Web: www.rihac.com.

3Installation Manual IP3000, IP4000, IP5000, MP760, MP780, i860, i865 -100ml Series Version 3-2009 1) Printer pre-check. ...

4Instruction Manual For Canon Printers IP3000, IP4000, IP5000, MP760, MP780, I860 & I865 -100ml Series Congratulations on your purchase of a RI

5 b) After performing a head clean you must then perform Print Check Pattern. The computer will automatically ask you this, however if it does no

62) Preparing your new CISS for installation Please ensure the following are present with your CISS. (1) Air filters x5 (2) Silicone nozzle

7 a) Carefully remove the small travel plugs on the CISS, leaving the filler plug in place. b) Using the syringe, remove any excess ink fr

8c) Place the CISS unit on the right hand side of your printer and Insert all the air filters into the top of each air balance chamber. The larger e

9 d) Carefully place each silicone nozzle seal into position around each of the printer heads as shown. Incorrectly placed silicone seals ca